ATEQ TPMS Reset Procedure (Integrated KEYHEAD Transmitter - IKT)

NOTE: This procedure also applies to models with Integrated Keyhead Transmitter (IKT) type of Remote Keyless Entry system.

Set the tire pressure of all wheels to pressure specified on the tire and loading information label.
Turn ignition switch (or Start/Stop button) to OFF position, then press and release brake pedal.
Turn ignition switch (or Start/Stop button) from OFF position to the RUN position 3 times, ending in RUN position. Do not wait more than one minute between each key cycle.
Press and release the brake pedal.
Turn ignition switch (or Start/Stop button) to OFF position.
Turn ignition switch (or Start/Stop button) from OFF position to the RUN position 3 times, ending in RUN position. Do not wait more than one minute between each key cycle.
Place TPM3 on the Left Front tire wall at the valve stem. Press the "TEST" button. The horn will sound briefly to indicate that the tire pressure sensor has been recognized by the Driver's Door Module (DDM).

NOTE: Do not wait more than 2 minutes between training each sensor. If the wait time is more than 2 minutes the DDM will stop and the training procedure must be repeated from the beginning.

--Within 2 minutes after the horn sounds, place TPMS3 on the Right Front tire wall at the valve stem. Then press the test button to train the Right Front tire pressure sensor. Repeat procedure for Right Rear and Left Rear tires.
When the tire training procedure is complete, the message center (if equipped) will display "TIRE TRAINING COMPLETE". For vehicles not equipped with a message center, successful completion of the training procedure will be verified by turning the ignition switch to the OFF position without the horn sounding. If the horn sounds twice when ignition is turned off, the training procedure was not successful.