Remote Keyless Entry (RKE) Transmitter Programming: Programming

NOTE: All RKE transmitters must be programmed at the same time. Entering the programming mode erases all previously programmed RKE transmitters (Integrated Keyhead Transmitters (IKTs) and key fobs). The PATS portion of the programmed Integrated Keyhead Transmitters (IKTs) is unaffected.

NOTE: There is no indication (audible or visual confirmation) when entering or existing RKE programming mode or when the RKE transmitter(s) has been programmed to the vehicle. The steps in the procedure must be completed within the time noted in each step.

WARNING: Before beginning any service procedure, refer to HEALTH AND SAFETY PRECAUTIONS . Failure to follow this instruction may result in serious personal injury.

Refer to: HEALTH AND SAFETY PRECAUTIONS .
Use the door lock control switch to unlock the doors.
Cycle the ignition from OFF to RUN to OFF 4 times in rapid succession (within 10 seconds), with the fourth turn ending in OFF.
NOTE: Programming mode ends when:
- the ignition transitions ON.
- 20 seconds elapse since entering programming mode or since the last RKE transmitter was programmed.
Within 20 seconds, press and hold any button on the RKE transmitter to be programmed. Repeat this step for each RKE transmitter.
Check the operation of the RKE transmitters. If the door locks do not respond for the programmed RKE transmitter(s), wait several seconds and press the button again. If the door locks still fail to respond, Refer to: LOCKS, LATCHES AND ENTRY SYSTEMS .