DTC P062F: Internal Control Module EEPROM Error

DTC P062F: INTERNAL CONTROL MODULE EEPROM ERROR

Description:	This DTC sets when the PCM read only memory (ROM) has been corrupted.
Possible Causes:	Aftermarket performance products An attempt was made to change the calibration PCM programming error PCM internal software error Damaged PCM
Diagnostic Aids:	Reprogram or update the calibration. Check for other DTCs or drive symptoms for further action. Check for aftermarket performance products before installing a new PCM. If it is necessary to install a new PCM, refer to OUTPUT STATE CONTROL (OSC) , Programming the VID Block for a Replacement PCM.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	Refer to the Description, Possible Causes and Diagnostic Aids for the DTC. Refer to the appropriate articles related to the description, possible causes and diagnostic aids.