DTC U2100: Initial Configuration Not Complete: Description

WARNING: This page is about a different car, the 2014 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

When a new EPAS gear is installed, the PSCM must be configured with the vehicle information. Configuration is checked during initial PSCM power up (ignition ON) with the voltage supply to the PSCM greater than 6 volts.

DTC U2100:00 (Initial Configuration Not Complete: No Sub Type Information) - This DTC sets if PSCM detects the vehicle data configuration or the component base data configuration is missing or incomplete. This is usually occurs when the initial PSCM configuration is not carried out or if the configuration fails.