LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2013 >> Escape Titanium, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 164 (Information System And Entertainment System) >> Removal And Installation >> Front Display Interface Module (FDIM) >> Removal and Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal and Installation

WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Module configuration is required when a new Front Display Interface Module (FDIM) is being installed.

    Upload the FDIM configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION to carry out Programmable Module Installation (PMI).

  2. Remove the center instrument panel finish panel. For additional information, refer to the INSTRUMENT PANEL AND CONSOLE .
  3. Remove the 4 screws and the FDIM.
    • Disconnect the electrical connector.
  4. To install, reverse the removal procedure.
    • Download the configuration information to the FDIM. For additional information, refer to MODULE CONFIGURATION to carry out PMI.
scientia non olet · About LEMON Manuals