Restraints Control Module (RCM): Installation

WARNING: This page is about a different car, the 2015 Ford C-Max. However, it is still accessible from the selected car via links, so may be relevant.

1.

To install, reverse the removal procedure.

2.

If the SRS was depowered, repower the SRS. Do not prove out the SRS at this time. Refer to: Supplemental Restraint System (SRS) Depowering and Repowering .

3.

NOTE: This step is only necessary when installing a new component.

Using a diagnostic scan tool, complete the PMI process for the RCM following the on-screen instructions.

4.

NOTE: This step is only necessary when installing a new component.

Using a diagnostic scan tool, carry out the ABS module initialization following the on-screen instruction.

5.
- If a new RCM was installed, prove out the SRS as follows: Turn the ignition from ON to OFF. Wait 10 seconds, then turn the ignition back to ON and monitor the air bag warning indicator with the air bag modules installed. The air bag warning indicator illuminates continuously for approximately 6 seconds and then turns off. If a SRS fault is present, the air bag warning indicator either fails to light, remains lit continuously or flashes.
- The flashing might not occur until approximately 30 seconds after the ignition has been turned from OFF to ON. This is the time required for the RCM to complete the testing of the SRS. If the air bag warning indicator is inoperative and a SRS fault exists, a chime sounds in a pattern of 5 sets of 5 beeps. If this occurs, diagnose and repair the air bag warning indicator and any SRS faults.