Remote Function Actuator (RFA) Module: Installation

WARNING: This page is about a different car, the 2015 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If installing a new RFA module, the ignition cannot be turned ON until a parameter reset is performed and 2 keys are programmed to the vehicle. The RFA module still communicates with the scan tool with the ignition OFF. Use the previous scan tool session or start a scan tool session using the PCM part number or tear tag.

1.

To install, reverse the removal procedure.

2.

If installing a new RFA module carry out the parameter reset. Refer to: Passive Anti-Theft System (PATS) Parameter Reset - With Push Button Start . Refer to: Passive Anti-Theft System (PATS) Parameter Reset - Without Push Button Start .

3.

If installing a new RFA module carry out the key programming procedure. Refer to: Key Programming Using Diagnostic Equipment - Without Push Button Start . Refer to: Key Programming Using Diagnostic Equipment - With Push Button Start .

4.

Carry out the RFA module self-test (must include an on-demand self-test) and then repeat the self-test to confirm all DTCs have been cleared.