DTC U2100: Initial Configuration Not Complete: Description

The PSCM is self monitoring and will carry out self-tests at specific intervals (initial power up, power down, during normal operation, etc.). Each self-test requires the voltage supply to the PSCM to be between 10 and 16 volts and the vehicle speed to be below 2 km/h (1.24 mph) for the test to take place. If one or more of the self-tests should fail, then the module will set one or more DTCs.

• DTC U2100:00 (Initial Configuration Not Complete: No Sub Type Information) - This DTC will set if the initial PSCM configuration was not carried out or if the configuration fails. The PSCM is configured from as built data broadcast from the IPC over the HS-CAN. This DTC sets if the PSCM fails to receive the configuration data from the IPC.