Vertical Alignment

NOTE: In order to align the Cruise-Control Module (C-CM), which is a radar sensor unit, the front bumper cover must be removed to access the sensor and the vehicle must be in a wheel alignment bay station so that the vehicle is level.

NOTE: Damage to the C-CM bracket may affect correct alignment. When aligning the C-CM, inspect the C-CM bracket for damage and repair as necessary before carrying out the alignment procedure.

Remove the front bumper cover. For additional information, refer to BUMPERS .
Place the vehicle on a wheel alignment bay station.
Locate the C-CM radar sensor alignment screw.

Fig 1: Locating Cruise-Control Module Radar Sensor Alignment Screw
Courtesy of FORD MOTOR CO.
Place a combination square level on the face of the C-CM radar sensor unit and check the alignment.

Fig 2: Checking Cruise-Control Module Radar Sensor Unit Alignment
Courtesy of FORD MOTOR CO.
Keeping the combination square level on the face of the C-CM radar sensor unit, adjust the pitch of the sensor by using an E5 inverted Torx® bit to adjust the screw until the sensor is vertical and level.

Fig 3: Adjusting Cruise-Control Module Radar Sensor Pitch Using E5 Inverted Torx® Bit
Courtesy of FORD MOTOR CO.
NOTE: Prior to installing the front bumper cover, clean and remove any debris on the front or back of the cover.

Install the front bumper cover.