Driver Door Module (DDM)
DRIVER DOOR MODULE (DDM) DTC CHART
| DTC | Description | Action |
|---|---|---|
| B1087:83 | LIN Bus "A": Value Of Signal Protection Calculation Incorrect | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B1087:86 | LIN Bus "A": Signal Invalid | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B1087:88 | LIN Bus "A": Bus Off | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B1108:11 | Driver Door Central Locking Motor: Circuit Short To Ground | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B1108:15 | Driver Door Central Locking Motor: Circuit Short To Battery Or Open | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B110A:01 | Rear Door Driver Side Central Locking Motor: General Electrical Failure | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B1288:02 | Rear Lock Motor Common Circuit: General Signal Failure | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B12AB:11 | Front Window Position Sensor Power Supply: Circuit Short To Ground | REFER to: GLASS, FRAMES AND MECHANISMS (501-11 Glass, Frames and Mechanisms, Diagnosis and Testing). |
| B12B6:11 | Front Lock Motor Common Circuit: Circuit Short To Ground | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B12B6:15 | Front Lock Motor Common Circuit: Circuit Short To Battery Or Open | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| B12C2:11 | Puddle Lamp: Circuit Short To Ground | REFER to: INTERIOR LIGHTING (417-02 Interior Lighting, Diagnosis and Testing). |
| B12C2:15 | Puddle Lamp: Circuit Short To Battery Or Open | REFER to: INTERIOR LIGHTING (417-02 Interior Lighting, Diagnosis and Testing). |
| B12C3:11 | Rear Window Position Sensor Power Supply: Circuit Short To Ground | REFER to: GLASS, FRAMES AND MECHANISMS (501-11 Glass, Frames and Mechanisms, Diagnosis and Testing). |
| B12C4:11 | Mirror Turn Indicator: Circuit Short To Ground | REFER to: TURN SIGNAL AND HAZARD LAMPS (417-01 Exterior Lighting, Diagnosis and Testing). |
| B12C4:15 | Mirror Turn Indicator: Circuit Short To Battery Or Open | REFER to: TURN SIGNAL AND HAZARD LAMPS (417-01 Exterior Lighting, Diagnosis and Testing). |
| B12C5:02 | Front Window Lifter Motor Up Relay: General Signal Failure | REFER to: GLASS, FRAMES AND MECHANISMS (501-11 Glass, Frames and Mechanisms, Diagnosis and Testing). |
| B12C6:02 | Rear Window Lifter Motor Up Relay: General Signal Failure | REFER to: GLASS, FRAMES AND MECHANISMS (501-11 Glass, Frames and Mechanisms, Diagnosis and Testing). |
| B12C7:02 | Rear Window Lifter Motor Down Relay: General Signal Failure | REFER to: GLASS, FRAMES AND MECHANISMS (501-11 Glass, Frames and Mechanisms, Diagnosis and Testing). |
| B12C8:02 | Front Window Lifter Motor Down Relay: General Signal Failure | REFER to: GLASS, FRAMES AND MECHANISMS (501-11 Glass, Frames and Mechanisms, Diagnosis and Testing). |
| B12D8:11 | Mirror Heater Output: Circuit Short To Ground | GO to PINPOINT TEST C |
| B12D8:15 | Mirror Heater Output: Circuit Short To Battery Or Open | GO to PINPOINT TEST C |
| B12DC:02 | Front Window Motion/Position Sensor: General Signal Failure | REFER to: GLASS, FRAMES AND MECHANISMS (501-11 Glass, Frames and Mechanisms, Diagnosis and Testing). |
| B12DC:54 | Front Window Motion/Position Sensor: Missing Calibration | REFER to: GLASS, FRAMES AND MECHANISMS (501-11 Glass, Frames and Mechanisms, Diagnosis and Testing). |
| B12DD:02 | Rear Window Motion/Position Sensor: General Signal Failure | REFER to: GLASS, FRAMES AND MECHANISMS (501-11 Glass, Frames and Mechanisms, Diagnosis and Testing). |
| B12DD:54 | Rear Window Motion/Position Sensor: Missing Calibration | REFER to: GLASS, FRAMES AND MECHANISMS (501-11 Glass, Frames and Mechanisms, Diagnosis and Testing). |
| B12E9:02 | Rear Window Local Up/Down Switch: General Signal Failure | REFER to: GLASS, FRAMES AND MECHANISMS (501-11 Glass, Frames and Mechanisms, Diagnosis and Testing). |
| B12FF:11 | Rear Door Switch Illumination: Circuit Short To Ground | REFER to: INSTRUMENT PANEL CLUSTER (IPC) AND PANEL ILLUMINATION (413-00 Instrument Panel Cluster (IPC) and Panel Illumination, Diagnosis and Testing). |
| B12FF:15 | Rear Door Switch Illumination: Circuit Short To Battery Or Open | REFER to: INSTRUMENT PANEL CLUSTER (IPC) AND PANEL ILLUMINATION (413-00 Instrument Panel Cluster (IPC) and Panel Illumination, Diagnosis and Testing). |
| B1302:11 | Mirror Motor Common: Circuit Short To Ground | GO to PINPOINT TEST A |
| B1C09:11 | Driver Left/Right Mirror Motor: Circuit Short To Ground | GO to PINPOINT TEST B |
| B1C10:11 | Driver Up/Down Mirror Motor: Circuit Short To Ground | GO to PINPOINT TEST B |
| U0010:88 | Medium Speed Can Communication Bus: Bus Off | The module was unable to communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the scan tool to report this Diagnostic Trouble Code (DTC)). VERIFY the integrity of the connectors and wiring. |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| U0201:87 | Lost Communication With "Door Control Module C": Missing Message | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |
| U0300:00 | Internal Control Module Software Incompatibility: No Sub Type Information | CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the Diagnostic Trouble Code (DTC) is retrieved again, INSTALL a new Driver Door Module (DDM). REFER to: DOOR MODULE (419-10 Multifunction Electronic Modules, Removal and Installation). |
| U0401:00 | Invalid Data Received From ECM/PCM A: No Sub Type Information | RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the Powertrain Control Module (PCM). REFER to: ELECTRIC POWERTRAIN CONTROL (303-14 Electric Powertrain Control, Diagnosis and Testing). |
| U0402:00 | Invalid Data Received From TCM: No Sub Type Information | RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the Transmission Control Module (TCM). REFER to: TRANSMISSION CONTROL MODULE (TCM) (307-01 Transmission, Diagnosis and Testing). |
| U0422:00 | Invalid Data Received From Body Control Module: No Sub Type Information | RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the Body Control Module (BCM). REFER to: BODY CONTROL MODULE (BCM) (419-10 Multifunction Electronic Modules, Diagnosis and Testing). |
| U2013:01 | Switch Pack: General Electrical Failure | INSTALL a new master window control switch. REFER to: GLASS, FRAMES AND MECHANISMS (501-11 Glass, Frames and Mechanisms, Diagnosis and Testing). |
| U2014:44 | Control Module Hardware: Data Memory Failure | CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the Diagnostic Trouble Code (DTC) is retrieved again, INSTALL a new Driver Door Module (DDM). REFER to: DOOR MODULE (419-10 Multifunction Electronic Modules, Removal and Installation). |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the Diagnostic Trouble Code (DTC) is retrieved again, INSTALL a new Driver Door Module (DDM). REFER to: DOOR MODULE (419-10 Multifunction Electronic Modules, Removal and Installation). |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If the Diagnostic Trouble Code (DTC) is retrieved again, INSTALL a new Driver Door Module (DDM). REFER to: DOOR MODULE (419-10 Multifunction Electronic Modules, Removal and Installation). |
| U3003:62 | Battery Voltage: Signal Compare Failure | REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS (501-14 Handles, Locks, Latches and Entry Systems, Diagnosis and Testing). |