LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2013 >> Focus S, Automatic DCT Trans, Gas >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Controls - 2.0L DURATEC-He >> Removal and Installation >> Powertrain Control Module (PCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (PCM): Installation

  1. To install, reverse the removal procedure.
    2. NOTE: This step is only necessary when installing a new component.
  2. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure.

    Refer to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION .

    General Equipment  : Ford Diagnostic Equipment

  3. Reprogram the PATS

    Refer to: Passive Anti-Theft System (PATS) Parameter Reset  ( PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET ).

    Refer to: Passive Anti-Theft System (PATS) Parameter Reset  ( PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET (Push Button Start) ).

scientia non olet · About LEMON Manuals