Image Processing Module - B (IPM-B) DTC Table
IMAGE PROCESSING MODULE - B (IPM-B) DTC CHART
| DTC | Description | Action |
|---|---|---|
| B115E:08 | Camera Module: Bus Signal / Message Failure | GO to Pinpoint Test S |
| B115E:49 | Camera Module: Internal Electronic Failure | CLEAR the DTC. REPEAT the self-test. If DTC B115E:49 returns, INSTALL a new video camera. For the 4-door, REFER to: Parking Aid Camera - 4-Door . For the 5-door, REFER to: Parking Aid Camera - 5-Door . |
| B115E:54 | Camera Module: Missing Calibration | DTC B115E:54 sets in the Image Processing Module - B (IPM-B) when the video camera is not calibrated. Turn the ignition ON for 5 minutes to allow the Image Processing Module - B (IPM-B)/camera flash operation to complete. |
| B115E:55 | Camera Module: Not Configured | DTC B115E:55 sets in the Image Processing Module - B (IPM-B) when the video camera is not configured. Turn the ignition ON for 5 minutes to allow the Image Processing Module - B (IPM-B)/camera flash operation to complete. |
| C115E:51 | Camera Module Flashing Active: Not Programmed | DTC B115E:55 sets in the Image Processing Module - B (IPM-B) when the video camera is not programmed. Turn the ignition ON for 5 minutes to allow the Image Processing Module - B (IPM-B)/camera flash operation to complete. |
| U0010:88 | Medium Speed CAN Communication Bus: Bus off | The Image Processing Module - B (IPM-B) has detected a network fault. To diagnose the communication network, REFER to: COMMUNICATIONS NETWORK . |
| U0140:87 | Lost Communication With Body Control Module: Missing Message | GO to Pinpoint Test Z |
| U0155:87 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: Missing Message | GO to Pinpoint Test W |
| U2100:55 | Initial Configuration Not Complete: Not Configured | CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT the Programmable Module Installation (PMI) procedure as directed by the scan tool. REFER to Programmable Module Installation (PMI). REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . If there have been no recent service actions, INSTALL a new Image Processing Module - B (IPM-B) to correct the failure to retain configuration data. For the 4-door, REFER to: Image Processing Module B (IPMB) - 4-Door . For the 5-door, REFER to: Image Processing Module B (IPMB) - 5-Door . |
| U3006:16 | Control Module Input Power "A": Circuit Voltage Below Threshold | GO to Pinpoint Test X |
| U3006:17 | Control Module Input Power "A": Circuit Voltage Above Threshold | GO to Pinpoint Test Y |