Front Control/Display Interface Module (FCDIM) - Base DTC Table
FCDIM DTC CHART - BASE
| DTC | Description | Action |
|---|---|---|
| B10BD:11 | Multifunctional Switch: Circuit Short to Ground | GO to Pinpoint Test M |
| B10BD:13 | Multifunctional Switch: Circuit Open | GO to Pinpoint Test M |
| B10BD:23 | Multifunctional Switch: Signal Stuck Low | GO to Pinpoint Test M |
| U0001:88 | High Speed CAN Communication Bus: Bus Off | REFER to: COMMUNICATIONS NETWORK . See No High Speed Controller Area Network (HS-CAN) Communication, All Modules Are Not Responding |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test O |
| U0155:00 | Lost Communication With IPC Module: No Sub Type Information | GO to Pinpoint Test P |
| U0423:68 | Invalid Data Received From IPC: Event Information | RETRIEVE and FOLLOW Diagnostic Trouble Codes (DTCs) present in the IPC. REFER to: INSTRUMENTATION, MESSAGE CENTER AND WARNING CHIMES . See DTC chart. |
| U1A00:00 | Private Communication Network: No Sub Type Information | GO to Pinpoint Test J |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | CHECK vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT/PERFORM the Programmable Module Installation (PMI) procedure as directed by the diagnostic scan tool. REFER to: COMMUNICATIONS NETWORK - SYSTEM OPERATION AND COMPONENT DESCRIPTION . See Programmable Module Installation (PMI). If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to: Front Control/Display Interface Module (FCDIM) . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | CHECK vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT/PERFORM the Programmable Module Installation (PMI) procedure as directed by the diagnostic scan tool. REFER to: COMMUNICATIONS NETWORK - SYSTEM OPERATION AND COMPONENT DESCRIPTION . See Programmable Module Installation (PMI). If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to: Front Control/Display Interface Module (FCDIM) . |
| U3000:00 | Control Module: No Sub Type Information | CLEAR the DTC. WAIT 10 seconds. REPEAT the self-test. If DTC U3000:00 is still present, INSTALL a new FCDIM. REFER to: Front Control/Display Interface Module (FCDIM) . |
| U3006:16 | Control Module Input Power "A": Circuit Voltage Below Threshold | GO to Pinpoint Test T |
| U3006:16 | Control Module Input Power "A": Circuit Voltage Above Threshold | GO to Pinpoint Test U |