Remote Function Actuator (RFA) Module DTC Table

RFA DTC CHART

DTC	Description	Action
B102B:00	Passive Key: No Sub Type Information	REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS) .
B102B:05	Passive Key: System Programming Failure	Less than 2 keys are programmed. PROGRAM additional keys (minimum of 2 keys must be programmed). REFER to: KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT .
B10C1:24	Left Front Unlock Pull Switch: Signal Stuck High	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B10C2:24	Left Rear Unlock Pull Switch: Signal Stuck High	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B10C3:24	Right Front Unlock Pull Switch: Signal Stuck High	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B10C4:24	Right Rear Unlock Pull Switch: Signal Stuck High	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B10C5:24	Trunk Unlock Pull Switch: Signal Stuck High	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B10C6:1F	Exterior Trunk Antenna: Circuit Intermittent	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B10C7:1F	Interior Trunk Antenna: Circuit Intermittent	REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10C8:1F	Interior Centre Antenna: Circuit Intermittent	REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10C9:1F	Interior Front Antenna: Circuit Intermittent	REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS) .
B10CA:1F	Left Rear Door Handle Antenna: Circuit Intermittent	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B10CB:1F	Right Rear Door Handle Antenna: Circuit Intermittent	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B10D1:24	Left Front Lock button: Signal Stuck High	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B10D3:24	Right Front Lock button: Signal Stuck High	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B11CC:51	Immobilizer Keyless Vehicle Secret Key: Not Programmed	There is no BCM ID stored in the RFA module. CARRY OUT a parameter reset, then CYCLE the ignition and make an attempt to start the vehicle. REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET .
B1361:00	Front Right Door Handle Lock Circuit: No Sub Type Information	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B1365:00	Front Left Door Handle Lock Circuit: No Sub Type Information	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B1367:00	Right Rear Door Handle Unlock Circuit: No Sub Type Information	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B136F:00	Left Front Door Handle Unlock Circuit: No Sub Type Information	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B1370:23	Door Handle Ground Supply: Signal Stuck Low	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B1370:24	Door Handle Ground Supply: Signal Stuck High	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B1372:00	Left Rear Door Handle Unlock Circuit: No Sub Type Information	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B1373:00	Front Right Door Handle Unlock Circuit: No Sub Type Information	REFER to: LOCKS, LATCHES AND ENTRY SYSTEMS ).
B1399:00	Personalized Key Synchronization: No Sub Type Information	ERASE and program all of the customer's keys. REFER to: KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT (Passive Anti-Theft System (PATS) - Push Button Start) or REFER to: KEY PROGRAMMING USING TWO PROGRAMMED KEYS .
U0010:00	Medium Speed CAN Communication Bus: No Sub Type Information	The module cannot communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the scan tool to report this DTC). VERIFY the integrity of the connectors and wiring. Refer to MODULE COMMUNICATION NETWORK for schematic and connector information. If no faults are found, INSTALL a new RFA module. REFER to: Remote Function Actuator (RFA) Module .
U0140:00	Lost Communication With Body Control Module: No Sub Type Information	GO to Pinpoint Test A
U0300:00	Internal Control Module Software Incompatibility: No Sub Type Information	CLEAR the DTCs and REPEAT the self-test. If the DTC is retrieved again, INSTALL a new RFA module. REFER to: Remote Function Actuator (RFA) Module .
U201B:54	Control Module Calibration Data #2: Missing Calibration	CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT the Programmable Module Installation (PMI) procedure as directed by the scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . If there have been no recent service actions, INSTALL a new RFA module. REFER to: Remote Function Actuator (RFA) Module .
U201F:00	External Receiver: No Sub Type Information	REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS) .
U201F:13	External Receiver: No Sub Type Information	REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS) .
U201F:87	External Receiver: Missing Message	REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS) .
U2100:00	Initial Configuration Not Complete: No Sub Type Information	CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT the Programmable Module Installation (PMI) procedure as directed by the scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . If there have been no recent service actions, INSTALL a new RFA module. REFER to: Remote Function Actuator (RFA) Module .
U2101:00	Control Module Configuration Incompatible: No Sub Type Information	CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT the Programmable Module Installation (PMI) procedure as directed by the scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . If there have been no recent service actions, INSTALL a new RFA module. REFER to: Remote Function Actuator (RFA) Module .
U3000:49	Control Module: Internal Electronic Failure	INSTALL a new RFA module. REFER to: Remote Function Actuator (RFA) Module .
U3002:81	Vehicle Identification Number: Invalid Serial Data Received	CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT the Programmable Module Installation (PMI) procedure as directed by the scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . If there have been no recent service actions, INSTALL a new RFA module. REFER to: Remote Function Actuator (RFA) Module .
U3003:62	Battery Voltage: Signal Compare Failure	GO to Pinpoint Test B