Front Controls Interface Module (FCIM) - Sony Sound DTC Table

FCIM DTC CHART - SONY SOUND

DTC	Description	Action
U0009:88	High Speed CAN Communication Bus (-) shorted to Bus (+): Bus off	The module was unable to communicate on the network at a point in time. The fault is not currently present (the module had to communicate with the diagnostic scan tool to report this DTC. VERIFY the integrity of the connectors and wiring. Refer to MODULE COMMUNICATION NETWORK for schematic and connector information.
U0155:00	Lost Communication With IPC Control Module: No Sub Type Information	GO to Pinpoint Test AG
U0423:00	Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information	RETRIEVE and FOLLOW Diagnostic Trouble Codes (DTCs) present in the IPC. REFER to: INSTRUMENTATION, MESSAGE CENTER AND WARNING CHIMES .
U2013:63	Switch Pack: Circuit/Component Protection Time-Out	CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U2013:63 is retrieved again, INSTALL a new FCIM. REFER to: Front Controls Interface Module (FCIM) .
U3000:41	Control Module: General Checksum Failure	CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new FCIM. REFER to: Front Controls Interface Module (FCIM) .
U3000:42	Control Module: General Memory Failure	CLEAR the Diagnostic Trouble Codes (DTCs). WAIT at least 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new FCIM. REFER to: Front Controls Interface Module (FCIM) .
U3003:16	Battery Voltage: Circuit Voltage Below Threshold	GO to Pinpoint Test AM
U3003:17	Battery Voltage: Circuit Voltage Above Threshold	GO to Pinpoint Test AN