Vertical Alignment

WARNING: This page is about a different car, the 2015 Lincoln MKS. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: In order to align the Cruise-Control Module (C-CM), which is a radar sensor unit, the vehicle must be in a wheel alignment bay station so that the vehicle is level.

NOTE: Damage to the C-CM bracket may affect correct alignment. When aligning the C-CM, inspect the C-CM bracket for damage and repair as necessary before carrying out the alignment procedure.

NOTE: If the front bumper cover has already been removed because of module replacement, there is no need to carry-out the first 2 steps.

1.

Remove the front lower air deflector. For additional information, refer to Bumper - Exploded View, Front in Bumpers .

2.

NOTE: When removing the C-CM radar sensor fascia cover retaining nut, make sure the cover stud is held with pliers to prevent twisting the stud off the cover.

Remove the C-CM radar sensor fascia cover retaining nut and cover.

Courtesy of FORD MOTOR COMPANY

3.

Place the vehicle on a wheel alignment bay station.

4.

Locate the C-CM radar sensor alignment screw.

Courtesy of FORD MOTOR COMPANY

5.

Place a combination square level on the face of the C-CM radar sensor unit and check alignment.

Courtesy of FORD MOTOR COMPANY

6.

Keeping the combination square level on the face of the C-CM radar sensor unit, adjust the pitch of the sensor by using an E5 inverted Torx ® bit to adjust the screw until the sensor is vertical and level.

Courtesy of FORD MOTOR COMPANY

7.

NOTE: Prior to installing the C-CM radar sensor fascia cover or front bumper cover, clean and remove any debris on the front or back of the cover.

Install the C-CM radar sensor fascia cover and retaining nut or front bumper cover.