Fuel System Pressure Check: Check

WARNING: Before beginning any service procedure, refer to SAFETY WARNINGS . Failure to follow this instruction may result in serious personal injury.

NOTE: This Fuel System Pressure Check is for the low pressure side of the system.

Refer to: GASOLINE AND GASOLINE-ETHANOL FUEL SYSTEMS HEALTH AND SAFETY PRECAUTIONS .
Release the fuel system pressure.
Refer to: FUEL SYSTEM PRESSURE RELEASE .
Disconnect the battery ground cable.
Refer to: BATTERY DISCONNECT AND CONNECT .
Remove the air cleaner outlet pipe.
Refer to: AIR CLEANER OUTLET PIPE .
Disconnect the fuel jumper tube-to-high pressure pump quick release coupling.
Refer to: SPRING LOCK COUPLINGS .
Install the Fuel Pressure Test Kit between the fuel jumper tube and the fuel tube.
Use Special Service Tool: 310-D009 (D95L-7211-A) Fuel Pressure Test Kit .
NOTE: The FPDM electrical connector was previously disconnected to release the fuel system pressure and must be reconnected to test the fuel system pressure.

Reconnect the FPDM electrical connector.
Connect the battery ground cable.
NOTE: Carry out a Key ON Engine OFF (KOEO) visual inspection for fuel leaks prior to completing the fuel system pressure test.

NOTE: After completion of the fuel system pressure test, open the drain valve on the Fuel Pressure Test Kit and release any residual fuel into a suitable container prior to removing the tool.

Test the fuel system pressure to make sure it is within the specified range. For additional information, refer to SPECIFICATIONS .