LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2014 >> Escape S >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (MULTIFUNCTION Electronic Modules) >> Diagnosis And Testing >> Body Control Module (BCM) >> Pinpoint Tests >> Pinpoint Test N: DTC U3003:17 >> Pinpoint Test N: DTC U3003:17
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pinpoint Test N: DTC U3003:17

WARNING: This page is about a different car, the 2013 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. N1 CHECK FOR DTCs B1317, B1676, P0563 (PCM), U3003:17 OR U3006:17 SET IN OTHER MODULES 
    • Ignition ON.
    • Using a scan tool, retrieve all continuous memory DTCs.
    • Is DTC B1317, B1676, U3003:17, U3006:17 or P0563 (PCM) set in more than one module? 
    1. Yes  : REFER to CHARGING SYSTEM .
    2. No  : GO to N2.
  2. N2 CHECK THE BATTERY VOLTAGE 
    • Turn off all interior/exterior lights and accessories.
    • Start and run the engine at approximately 2, 000 rpm for 3 minutes while monitoring the battery voltage.
    • Does the battery voltage rise to 15.9 volts or higher? 
    1. Yes  : REFER to CHARGING SYSTEM .
    2. No  : GO to N3.
  3. N3 RECHECK FOR DTC U3003:17 
    • Turn the engine off.
    • Ignition ON.
    • Using a scan tool, perform the self-test.
    • Clear the continuous memory DTCs.
    • Carry out the BCM self-test.
    • Is DTC U3003:17 present? 
    1. Yes  : INSTALL a new BCM. REFER to BODY CONTROL MODULE (BCM) .
    2. No  : The system is operating normally at this time. The DTC may have been set previously during battery charging or while jump starting the vehicle.
scientia non olet · About LEMON Manuals