LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2014 >> Fiesta ST >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Engine System - General Information) >> Diagnosis And Testing >> Engine >> Compression Test - Compression Gauge Check >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Compression Test - Compression Gauge Check: Notes

WARNING: This page is about a different car, the 2013 Ford F-550 Super Duty, 2013 Ford F-450 Super Duty, 2013 Ford F-350 Super Duty, and 2013 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure the oil in the crankcase is of the correct viscosity and at the correct level and that the battery is correctly charged. Operate the vehicle until the engine is at normal operating temperature. Turn the ignition switch to the OFF position, then remove all the spark plugs.
  2. Set the throttle plates in the wide-open position.
  3. Install a compression gauge in the No. 1 cylinder.
  4. Install an auxiliary starter switch in the starting circuit. With the ignition switch in the OFF position, and using the auxiliary starter switch, crank the engine a minimum of 5 compression strokes and record the highest reading. Note the approximate number of compression strokes required to obtain the highest reading.
  5. Repeat the test on each cylinder, cranking the engine approximately the same number of compression strokes.
scientia non olet · About LEMON Manuals