LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2014 >> Focus S, Standard Trans, Gas >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Controls - 2.0L DURATEC >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (PCM): Installation

  1. To install, reverse the removal procedure.
  2. NOTE: This step is only necessary when installing a new component.

    Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure.

    Refer to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION .

    Use the General Equipment: Ford Diagnostic Equipment

  3. Reprogram the PATS 

    Refer to: PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET (Vehicles Without: Push Button Start).

    Refer to: PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET (Vehicles With: Keyless Entry and Push Button Start).

  4. After completing the repairs, perform the Misfire Monitor Neutral Profile Correction procedure.
scientia non olet · About LEMON Manuals