Front Control/Display Interface Module (FCDIM) - Base DTC Table

DTC IDEX

DTC	Description	Action
B10BD:11	Multifunctional Switch: Circuit Short to Ground	GO to PINPOINT TEST M
B10BD:13	Multifunctional Switch: Circuit Open	GO to PINPOINT TEST M
B10BD:23	Multifunctional Switch: Signal Stuck Low	GO to PINPOINT TEST M
U0001:88	High Speed CAN Communication Bus: Bus Off	NOTE: The module was unable to communicate on the network at a point in time. The fault is not currently present since the module had to communicate with the diagnostic scan tool to report this DTC . To avoid repeat network concerns: INSPECT for damaged or corroded wiring at the FCDIM . Refer to OEM WIRING DIAGRAMS -- EXCEPT ELECTRIC for schematic and connector information. CLEAR the DTC . WAIT at least 10 seconds. REPEAT the network test with the diagnostic scan tool.
U0140:00	Lost Communication With Body Control Module: No Sub Type Information	GO to PINPOINT TEST O
U0155:00	Lost Communication With IPC Module: No Sub Type Information	GO to PINPOINT TEST P
U0423:68	Invalid Data Received From IPC : Event Information	RETRIEVE and FOLLOW Diagnostic Trouble Codes (DTCs) present in the IPC . REFER to: INSTRUMENTATION, MESSAGE CENTER AND WARNING CHIMES . See DTC CHART.
U1A00:00	Private Communication Network: No Sub Type Information	GO to PINPOINT TEST J
U2100:00	Initial Configuration Not Complete: No Sub Type Information	CHECK vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT/PERFORM the Programmable Module Installation (PMI) procedure as directed by the diagnostic scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . See PROGRAMMABLE MODULE INSTALLATION (PMI) . If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to: FRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM) (Vehicles With: AM/FM/CD).
U2101:00	Control Module Configuration Incompatible: No Sub Type Information	CHECK vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT/PERFORM the Programmable Module Installation (PMI) procedure as directed by the diagnostic scan tool. REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . See PROGRAMMABLE MODULE INSTALLATION (PMI) . If there have been no recent service actions, INSTALL a new FCDIM to correct the failure to retain configuration data. REFER to: FRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM) (Vehicles With: AM/FM/CD).
U3000:00	Control Module: No Sub Type Information	CLEAR the DTC . WAIT 10 seconds. REPEAT the self-test. If DTC U3000:00 is still present, INSTALL a new FCDIM . REFER to: FRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM) (Vehicles With: AM/FM/CD).
U3006:16	Control Module Input Power "A": Circuit Voltage Below Threshold	GO to PINPOINT TEST T
U3006:16	Control Module Input Power "A": Circuit Voltage Above Threshold	GO to PINPOINT TEST U