Body Control Module (BCM) DTC Table
BCM DTC DESCRIPTION
| DTC | Description | Action |
|---|---|---|
| B10D5:94 | PATS Antenna: Unexpected Operation | The BCM received an incomplete or corrupt response from the transceiver. INSTALL a new PATS transceiver. REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS) TRANSCEIVER . |
| B10D7:05 | PATS Key: System Programming Failure | GO to PINPOINT TEST B |
| B10D7:51 | PATS Key: Not Programmed | There is an unprogrammed PATS key. PROGRAM the PATS key. REFER to: KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT . |
| B10D7:55 | PATS Key: Not Configured | The BCM Configurable Engine Immobilizer (CEI) was not configured after PMI . FOLLOW the diagnostic scan tool on-screen instructions after the PMI process to perform the Configurable Engine Immobilizer (CEI) Lock Configuration. |
| B10D7:81 | PATS Key: Invalid Serial Data Received | GO to PINPOINT TEST C |
| B10D7:87 | PATS Key: Missing Message | GO to PINPOINT TEST D |
| B10D7:94 | PATS Key: Unexpected Operation | GO to PINPOINT TEST C |
| B10D8:00 | PATS Key Less Than Minimum Programmed: No Sub Type Information | Less than 2 keys are programmed. PROGRAM additional keys (minimum of 2 keys must be programmed). CYCLE the customer's second key in the ignition to program (when less than 2 keys are programmed, the BCM automatically programs the first 2 keys that are cycled in the ignition lock cylinder). |
| B10DA:51 | PATS Target Identifier: Not Programmed | There is no BCM ID stored in the BCM memory. CARRY OUT a parameter reset. REFER to: PASSIVE ANTI-THEFT SYSTEM (PATS) PARAMETER RESET . |
| All other DTCs | - | REFER to: BODY CONTROL MODULE (BCM) . |