LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2014 >> Fusion S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 121 (Engine Controls - Fuel Charging And Controls - 1.6L) >> Removal And Installation >> Fuel Pump Driver Module (FPDM) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Pump Driver Module (FPDM): Removal

WARNING: This page is about a different variant/trim than selected.
WARNING: Before beginning any service procedure in this article, refer to Safety Warnings in GENERAL INFORMATION . Failure to follow this instruction may result in serious personal injury.
WARNING: Do not work on the fuel system until the pressure has been released and the engine has cooled. Fuel in the high-pressure fuel system is hot and under very high pressure. High-pressure fuel may cause cuts and contact with hot fuel may cause burns. Failure to follow these instructions may result in serious personal injury.
WARNING: Clean all fuel residue from the engine compartment. If not removed, fuel residue may ignite when the engine is returned to operation. Failure to follow this instruction may result in serious personal injury.
  1. NOTE: Removal steps in this procedure may contain installation details.

    Refer to: HEALTH AND SAFETY PRECAUTIONS .

  2. Refer to: C-PILLAR LOWER TRIM PANEL .
    1. 2. Torque:  13 lb.in (1.5 Nm)
      G08637529