Starting System DTCS: 2.0L: Pcm

DTC INDEX

DTC	Description	Action
P0512	Starter Request Circuit - Circuit has Power With the Ignition in the OFF Position	PERFORM the IGNITION SWITCH Component Test. Refer to OEM WIRING DIAGRAMS COMPONENT TESTING (EXCEPT HYBRID) for schematic and connector information. testing. If necessary, INSTALL a new ignition switch. If the ignition switch passed the component test, REPAIR circuit CDC35 (BU/WH) for a short to power.
P0616	Starter Relay "A" Circuit Low	GO to PINPOINT TEST C
P0617	Starter Relay "A" Circuit High	GO to PINPOINT TEST C
P06E9	Engine Starter Performance	If the engine cranks, Refer to ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) . If the engine does not crank, GO to PINPOINT TEST A
P0706	Transmission Range Sensor "A" Circuit Range/Performance	REFER to: AUTOMATIC TRANSMISSION - 2.0L ECOBOOST (184KW/250PS) - MI4 .
P0707	Transmission Range Sensor "A" Circuit Low	REFER to: AUTOMATIC TRANSMISSION - 2.0L ECOBOOST (184KW/250PS) - MI4
P0708	Transmission Range Sensor "A" Circuit High	REFER to: AUTOMATIC TRANSMISSION - 2.0L ECOBOOST (184KW/250PS) - MI4 .
P0830	Clutch Pedal Switch "A" Circuit	Refer to ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) .
P0833	Clutch Pedal Switch "B" Circuit	Refer to ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID) (SECTION 0) .
P1260	Theft Detected, Vehicle Immobilized	REFER to: ELECTRONIC ENGINE CONTROLS - 2.0L (EXCEPT HYBRID) .
P162F	Starter Motor Disabled - Engine Crank Time Too Long	This DTC sets in the PCM when the engine has been cranked for more than a total of 60 seconds without allowing sufficient time for the starter to cool. Diagnose all other DTCs and symptoms. Check the charging system voltage and correct as necessary. Clear the DTC.
P2535	Ignition Switch Run/Start Position Circuit High	GO to PINPOINT TEST E
All Other DTCs	-	REFER to: ELECTRONIC ENGINE CONTROLS - 2.0L (EXCEPT HYBRID) .