Body Control Module (BCM) DTC Table

BODY CONTROL MODULE (BCM) DTC CHART

DTC	Description	Action
B1182:00	Tire Pressure Monitoring System: No Sub Type Information	GO to PINPOINT TEST A
B1182:55	Tire Pressure Monitoring System: Not Configured	This DTC is only present when a new BCM is installed, or the BCM is flashed or reconfigured. This DTC clears when the BCM is correctly configured, all 4 TPMS sensors are trained to the BCM and the BCM self-test completes successfully. Using a diagnostic scan tool, CONFIGURE the BCM , REFER to: MODULE CONFIGURATION - SYSTEM OPERATION AND COMPONENT DESCRIPTION . TRAIN the TPMS sensors, REFER to: Tire Pressure Monitoring System (TPMS) Sensor Location Calibration . CARRY OUT a BCM self-test to clear the DTC .
B124D:02	Tire Pressure Sensor: General Signal Failure	ACTIVATE the TPMS sensors. REFER to: TIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR ACTIVATION . If DTC B124D:02 is retrieved again, GO to PINPOINT TEST E
B1251:00	Tire Pressure Sensor Low Battery: No Sub Type Information	GO to PINPOINT TEST C
B1254:51	Right Rear (Outside on Dual Wheel) Tire Pressure Sensor and Transmitter Assembly: Not Programmed	This DTC is only present when a new BCM is installed, or the BCM is flashed or reconfigured. This DTC is cleared after the TPMS senors locations are trained to the BCM . TRAIN the TPMS sensors, REFER to: Tire Pressure Monitoring System (TPMS) Sensor Location Calibration .
B1255:51	Left Rear (Outside On Dual Wheel) Tire Pressure Sensor and Transmitter Assembly: Not Programmed	This DTC is only present when a new BCM is installed, or the BCM is flashed or reconfigured. This DTC is cleared after the TPMS senors locations are trained to the BCM . TRAIN the TPMS sensors, REFER to: Tire Pressure Monitoring System (TPMS) Sensor Location Calibration .
C1A56:51	Left Front Tire Pressure Sensor and Transmitter Assembly: Not Programmed	This DTC is only present when a new BCM is installed, or the BCM is flashed or reconfigured. This DTC is cleared after the TPMS senors locations are trained to the BCM . TRAIN the TPMS sensors, REFER to: Tire Pressure Monitoring System (TPMS) Sensor Location Calibration .
C1A58:51	Right Front Tire Pressure Sensor and Transmitter Assembly: Not Programmed	This DTC is only present when a new BCM is installed, or the BCM is flashed or reconfigured. This DTC is cleared after the TPMS senors locations are trained to the BCM . TRAIN the TPMS sensors, REFER to: Tire Pressure Monitoring System (TPMS) Sensor Location Calibration .
-	All Other BCM Diagnostic Trouble Codes (DTCs)	REFER to: BODY CONTROL MODULE (BCM) .