LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2014 >> Mustang Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Controls - Fuel Charging And Controls - 5.8L) >> Removal And Installation >> Fuel Pump Control Module >> Removal and Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
NOTE: Each FPCM  is located in the spare tire stowage compartment and is serviced separately.
  1. Disconnect the FPCM  electrical connector.
  2. Remove the 2 nuts and the FPCM  .
    • Tighten to 8 Nm (71 lb-in).
  3. To install, reverse the removal procedure.