Pinpoint Test L: SCCM (Steering Column Control Module) Signal Failure Diagnostic Trouble Codes (DTCS): Notes
NOTE:
The SCCM is also known as the SASM and the steering wheel rotation sensor.
The SCCM monitors steering wheel rotation speed, angle and direction of rotation and sends the information to the ABS module over the HS-CAN. A failure of the HS-CAN, SCCM or the internal sensors causes the ABS module to set one or more Diagnostic Trouble Codes (DTCs).
DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| C0051:28 | Steering Wheel Position Sensor: Signal Bias Level Out of Range/Zero Adjustment Failure | This DTC sets in continuous memory and on-demand if the absolute value of the measured steering wheel angle sensor is greater than 720 degrees or if the calculated steering angle offset is greater than 15 degrees. This is most likely caused by loose or worn steering or suspension components that result in a vehicle tracking, pull or drift issue. Also, an incorrectly installed SCCM or clockspring may cause the steering angle to be offset. |
| U0428:00 | Invalid Data Received from Steering Angle Sensor Module: No : Sub Type Information | This DTC sets in continuous memory and on-demand if the steering angle status message sent by the SCCM indicates defective steering angle information. |
| U0428:2F | Invalid Data Received from Steering Angle Sensor Module: Signal Erratic | This is an intermittent DTC that is stored only due to temporary disturbances of the signals received from the SCCM. The steering angle is measured in increments of 1 degree. This DTC sets in continuous memory and on-demand if the steering angle sensor signal increases or decreases when it should remain stable. |
| U0428:61 | Invalid Data Received from Steering Angle Sensor Module: Signal Calculation Failure | This DTC sets in continuous memory and on-demand if the calculated steering angle and the actual steering angle differ by more than 15 degrees. This is most likely caused by an incorrectly installed or damaged SCCM but can also be caused by loose or worn steering or suspension components that result in excessive play in the steering system. |
| U0428:62 | Invalid Data Received from Steering Angle Sensor Module: Signal Compare Failure | These Diagnostic Trouble Codes (DTCs) set in continuous memory and on-demand if the steering angle sensor signal does not match other stability sensor signals (yaw rate, longitudinal acceleration, lateral acceleration, etc.). |
| U0428:64 | Invalid Data Received from Steering Angle Sensor Module: Signal Plausibility Failure | |
| U0428:68 | Invalid Data Received from Steering Angle Sensor Module: Event Information |