LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2015 >> Focus S, Standard Trans, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 66 (Module Communications Network (Electric Vehicle)) >> Diagnosis And Testing >> Communications Network >> DTC Chart(s)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Chart(s)

WARNING: This page is about a different variant/trim than selected.

Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .

DTC Chart: GWM 

DTC Description Action
U2100:00 Initial Configuration Not Complete: No Sub Type Information CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect Programmable Module Installation (PMI) procedures. If there have been recent service actions with this module, REPEAT the Programmable Module Installation (PMI) procedure as directed by the scan tool. REFER to: Module Configuration - System Operation and Component Description . If there have been no recent service actions, INSTALL a new GWM. REFER to: Gateway Module A (GWM) .
U3000:44 Control Module: Data Memory Failure PERFORM a GWM self-test. If DTC U3000:44 is retrieved, INSTALL a new GWM. REFER to: Gateway Module A (GWM) . If DTC U3000:44 is not retrieved, the module is operating correctly at this time. The concern may have been caused by an intermittent concern.
U3000:45 Control Module: Program Memory Failure PERFORM a GWM self-test. If DTC U3000:45 is retrieved, INSTALL a new GWM. REFER to: Gateway Module A (GWM) . If DTC U3000:45 is not retrieved, the module is operating correctly at this time. The concern may have been caused by an intermittent concern.

DTC Chart: BCM 

DTC Description Action
U0001:88 High Speed CAN Communication Bus: Bus Off A High Speed Controller Area Network (HS-CAN) fault was present at a point in time. The fault is not currently present since the module is communicating with the scan tool. CLEAR the DTC. REPEAT the network test with the scan tool. VERIFY the integrity of the connectors and wiring. Refer to MODULE COMMUNICATIONS NETWORK for schematic and connector information.
U0010:88 Medium Speed CAN Communication Bus: Bus Off A Medium Speed Controller Area Network (MS-CAN) fault was present at a point in time. The fault is not currently present since the module is communicating with the scan tool. CLEAR the DTC. REPEAT the network test with the scan tool. VERIFY the integrity of the connectors and wiring. Refer to MODULE COMMUNICATIONS NETWORK for schematic and connector information.
U0037:88 Vehicle Communication Bus B: Bus Off The module could not communicate with the network at a point in time. The fault is not currently present since the module had to communicate with the scan tool to report the DTC. CLEAR the DTC. REPEAT the network test with the scan tool. VERIFY the integrity of the connectors and wiring. Refer to MODULE COMMUNICATIONS NETWORK for schematic and connector information. If a communication concern is still present, GO to Pinpoint Test AB 
scientia non olet · About LEMON Manuals