LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2015 >> Focus ST >> Repair and Diagnosis >> Quick Lookups >> DTC Index (Except Electric) >> Exterior Lighting System DTCS >> Stoplamp >> Body Control Module (BCM) DTC Table
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Body Control Module (BCM) DTC Table

DTC INDEX

DTC Description Action
B1115:11 High Mounted Stop Lamp Control: Circuit Short to Ground GO to Pinpoint Test B
B1115:15 High Mounted Stop Lamp Control: Circuit Short to Battery or Open If the lamp is inoperative, GO to Pinpoint Test B
If the lamp is always on, GO to Pinpoint Test C
C111A:11 Right Stop Lamp: Circuit Short to Ground GO to Pinpoint Test B
C111A:15 Right Stop Lamp: Circuit Short to Battery or Open If the lamp is inoperative, GO to Pinpoint Test B
If the lamp is always on, GO to Pinpoint Test C
C111B:11 Left Stop Lamp: Circuit Short to Ground GO to Pinpoint Test B
C111B:15 Left Stop Lamp: Circuit Short to Battery or Open If the lamp is inoperative, GO to Pinpoint Test B
If the lamp is always on, GO to Pinpoint Test C
C1A96:24 Brake Light: Signal Stuck High GO to Pinpoint Test C
U1000:00 Solid State Driver Protection Active -Driver Disabled: No Sub Type Information The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test. For additional information on BCM Field Effect Transistor (FET) protection, REFER to: Module Controlled Functions - System Operation and Component Description
U3000:49 Control Module: Internal Electronic Failure The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. The cause of the excessive current draw MUST be corrected before a new BCM is installed. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, INSTALL a new BCM. REFER to: BODY CONTROL MODULE (BCM) For additional information on BCM Field Effect Transistor (FET) protection, REFER to: Module Controlled Functions - System Operation and Component Description
For other BCM Diagnostic Trouble Codes (DTCs) - REFER to: Body Control Module (BCM)