Side Obstacle Detection Control Module - Left (SOD-L) and Side Obstacle Detection Control Module - Right (SOD-R) DTC Chart
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to Diagnostic Methods in Service Information for information about these practices.
NOTE:
Refer to Description and Operation, IA with Push Button Start in
Anti-Theft - Passive Anti-Theft System (PATS), With Intelligent Access (IA)
to review the procedures for achieving the various ignition states (ignition in accessory, ignition on, ignition start, ignition off) on vehicles with this feature.
| DTC | Description | Action |
|---|---|---|
| B11D6:11 | Driver Display Alert LED: Circuit Short To Ground | GO to Pinpoint Test D . |
| B11D6:15 | Driver Display Alert LED: Circuit Short To Battery Or Open | If the LED is not illuminated GO to Pinpoint Test D . If the LED is always on GO to Pinpoint Test I . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | The Side Obstacle Detection Control Module - Left (SOD-L) or Side Obstacle Detection Control Module - Right (SOD-R) is not configured. REFER to Module Configuration for Programmable Module Installation (PMI) to configure the SOD-L or SOD-R. |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test J . |
| U0423:00 | Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information | DTC U0423:00 is set when the SOD-L or SOD-R receives invalid network data from the IPC. RETRIEVE and REPAIR all non-network DTCs in the IPC. REFER to Instrumentation, Message Center, and Warning Chimes . |
| U3000:44 | Control Module: Data Failure | GO to Pinpoint Test H . |
| U3000:45 | Control Module: Program Memory Failure | GO to Pinpoint Test H . |
| U3000:46 | Control Module: Calibration/Parameter Memory Failure | GO to Pinpoint Test H . |
| U3000:48 | Control Module: Supervision Software Failure | GO to Pinpoint Test H . |
| U3000:49 | Control Module: Internal Electronic Failure | GO to Pinpoint Test H . |
| U3000:4A | Control Module: Incorrect Component Installed | GO to Pinpoint Test H . |