Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2016 Ford Transit-350 HD, 2016 Ford Transit-350, 2016 Ford Transit-250, and 2016 Ford Transit-150. However, it is still accessible from the selected car via links, so may be relevant.
With the ignition ON, the diagnostic scan tool communicates with the ABS module over the HS-CAN2. Communications can be interrupted by a wiring condition such as a short to ground, a short to voltage or an open circuit; module failure is also a cause of no communication.
Possible Causes
- Fuse
- ABS module
- Wiring, terminals or connectors
- AR1: VERIFY THE NO COMMUNICATION DIAGNOSTICS HAVE BEEN PERFORMED NOTE: Diagnostics in Module Communications Network MUST BE CARRIED OUT before continuing with this pinpoint test.
- Has the appropriate pinpoint test in Module Communications Network
been carried out for the no communication concern?
Yes No INSTALL a new ABS module.
CHECK OASIS for any applicable TSBs. If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no TSBs address this concern, INSTALL a new ABS module.REFER to Module Communications Network and CARRY OUT the ABS module does not respond to the diagnostic scan tool pinpoint test.
- Has the appropriate pinpoint test in Module Communications Network
been carried out for the no communication concern?