Pinpoint Test A : DTC (Diagnostic Trouble Code) P0562:00: Notes
WARNING: This page is about a different car, the 2017 Ford F-550 Super Duty, 2017 Ford F-450 Super Duty, 2017 Ford F-350 Super Duty, and 2017 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
Refer to Four Wheel Drive Systems for schematic and connector information.
Normal Operation
The MSS communicates the operator's choice to the TCCM. The TCCM then controls the transfer case clutch, transfer case motor and continuous vacuum hublocks (CVH) as necessary. If the vehicle is not responding to the operator's intentions, systematically check the necessary inputs and outputs of the TCCM, components of the transfer case, continuous vacuum hublocks (CVH) components and halfshafts. Check all circuits for opens and shorts to power or ground.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P0562:00 | System Voltage Low: No Sub Type Information | This DTC sets when the TCCM detects less than 9 volts of battery voltage for 5 seconds or more at TCCM. |
Possible Sources
- Wiring, terminals or connectors
- TCCM
NOTE:
DTCs P0562:00 can set if the vehicle has been recently jump started, or the battery has been recently charged or discharged. The battery may become discharged due to excessive load(s) on the charging system from aftermarket accessories or if the battery has been left unattended with the accessories on.
NOTE:
Carry out a thorough inspection and verification before proceeding with the pinpoint test.