Qt3 Carry Out The Pcm Quick Test
WARNING: This page is about a different variant/trim than selected.
NOTE:
If unable to access the PCM or a scan tool communication concern exists, GO to Pinpoint Test AE
.
- Connect the scan tool to the data link connector (DLC). Refer to SCAN TOOL SETUP AND FUNCTIONALITY .
- Carry out the PCM Quick Test to access and record any key ON, engine OFF (KOEO), key ON, engine running (KOER) and continuous memory DTCs. Refer to QUICK TEST DESCRIPTION .
- Access and record the Freeze Frame Data. Refer to FREEZE FRAME DATA .
Are any DTCs present?
| Yes | No |
|---|---|
| GO to
DIAGNOSTIC TROUBLE CODE (DTC) CHARTS AND DESCRIPTIONS
to diagnose the DTCs after noting the following: DIAGNOSE the circuit related DTCs first. For multiple circuit DTCs that are set as a result of a concern with more than one component, REFER to the Wiring Diagrams and IDENTIFY the common cause such as SIGRTN, VREF, or VPWR. CONTINUE DTC diagnosis by referring to the appropriately identified pinpoint test. Any KOEO self-test DTCs Any KOER self-test DTCs Any continuous memory self-test DTCs. Retrieve any available freeze frame data and disregard any identical or related continuous DTCs already repaired. |
GO to NO DIAGNOSTIC TROUBLE CODES (DTCS) PRESENT SYMPTOM CHART INDEX for direction to the symptom chart in NO DIAGNOSTIC TROUBLE CODES (DTCS) PRESENT SYMPTOM CHARTS . If the symptom is not listed, REFER to the applicable service information to continue diagnosis. |