Pinpoint Test WA: Exhaust Gas Recirculation Temperature (EGRT) Sensor: Introduction

WARNING: This page is about a different variant/trim than selected.

NOTE: Regeneration may occur during normal operation. During regeneration, diagnostic procedures may display biased values. If a regeneration occurs during diagnostic procedures, allow the process to complete before continuing diagnostics.

This pinpoint test is intended to diagnose the following:

harness circuits: EGRT11, EGRT12, and SIGRTN
EGRT11 and EGRT12 sensors
PCM (12A650)

Fig 1: Identifying Exhaust Gas Recirculation Temperature Bank 1, Sensor 1 (EGRT11) Connector

Courtesy of FORD MOTOR CO.

Pin	Circuit
2	SIGRTN (Signal Return)
1	EGRT11 (Exhaust Gas Recirculation Temperature Bank 1, Sensor 1)

Fig 2: Identifying Exhaust Gas Recirculation Temperature Bank 1, Sensor 2 (EGRT12) Connector

Courtesy of FORD MOTOR CO.

Pin	Circuit
2	SIGRTN (Signal Return)
1	EGRT12 (Exhaust Gas Recirculation Temperature Bank 1, Sensor 2)

Fig 3: Identifying Powertrain Control Module-E (PCM-E) Connector

Courtesy of FORD MOTOR CO.

Pin	Circuit
37	EGRT12 (Exhaust Gas Recirculation Temperature Bank 1, Sensor 2)
4	SIGRTN (Signal Return)
27	EGRT11 (Exhaust Gas Recirculation Temperature Bank 1, Sensor 1)