Driver Front Seat Module (DSM): Removal
NOTE:
Removal steps in this procedure may contain installation details.
- 1.NOTE: This step is only necessary when installing a new component.NOTE: The PMI process must begin with the current DSM installed. If the current DSM does not respond to the diagnostic scan tool, the tool may prompt for As-Built Data as part of the repair.
Using a diagnostic scan tool, begin the PMI process for the DSM following the on-screen instructions.
- 2.NOTE: The DSM outboard mounting tab is located under the front seat front shield.
Remove the screws, disconnect the electrical connectors and remove the DSM.
Torque: 44 lb.in (5 Nm)