| B1088:83 |
LIN Bus "B": Value of Signal Protection Calculation Incorrect |
GO to Pinpoint Test C |
| B1088:87 |
LIN Bus "B": Missing Message |
GO to Pinpoint Test C |
| B117E:07 |
Front Power Window Up: Mechanical Failure |
INITIALIZE the driver door window regulator motor. REFER to: Power Door Window Initialization
. |
| B117E:16 |
Front Power Window Up: Circuit Voltage Below Threshold |
GO to Pinpoint Test C |
| B117E:4B |
Front Power Window Up: Over Temperature |
WAIT 10 minutes to allow the window motor to cool. INITIALIZE the driver door window regulator motor. REFER to: Power Door Window Initialization
. VERIFY the DTC is no longer present. If the DTC returns, INSPECT the window seals, glass runs and window regulator for a binding condition. REPAIR as necessary. |
| B117E:92 |
Front Power Window Up: Performance or Incorrect Operation |
INITIALIZE the driver door window regulator motor. REFER to: Power Door Window Initialization
. |
| B1189:29 |
Front Window Position Sensor: Signal Invalid |
GO to Pinpoint Test C |
| B12C5:71 |
Front Window Lifter Motor Up Relay: Actuator Stuck |
GO to Pinpoint Test C |
| B12C8:71 |
Front Window Lifter Motor Down Relay: Actuator Stuck |
GO to Pinpoint Test C |
| B13F1:4B |
Driver Power Window Motor: Over Temperature |
CLEAR the DTC. WAIT 10 minutes to allow the window motor to cool. INITIALIZE the driver door window regulator motor. REFER to: Power Door Window Initialization
. VERIFY the DTC is no longer present. If the DTC returns, INSPECT the window seals, glass runs and window regulator for a binding condition. REPAIR as necessary. |
| C1B14:11 |
Sensor Supply Voltage A: Circuit Short To Ground |
GO to Pinpoint Test C |
| C1B14:15 |
Sensor Supply Voltage A: Circuit Short To Battery or Open |
GO to Pinpoint Test C |
| U2013:24 |
Switch Pack: Signal Stuck High |
INSTALL a new driver door window control switch. REFER to: Driver Door Window Control Switch
. |
| All other Diagnostic Trouble Codes (DTCs) |
- |
REFER to: Locks, Latches and Entry Systems
. |