Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2016 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
With the ignition ON, the diagnostic scan tool communicates with the ABS module over the HS-CAN2. Communications can be interrupted by a wiring condition such as a short to ground, a short to voltage or an open circuit; module failure is also a cause of no communication.
Possible Causes
- Fuse
- Wiring, terminals or connectors
- ABS module
- AT1: VERIFY THE NO COMMUNICATION DIAGNOSTICS HAVE BEEN PERFORMED NOTE: Diagnostics in MODULE COMMUNICATIONS NETWORK MUST BE CARRIED OUT before continuing with this pinpoint test.
- Carry out the appropriate pinpoint test in MODULE COMMUNICATIONS NETWORK .
- Has the appropriate pinpoint test in MODULE COMMUNICATIONS NETWORK
been carried out for the no communication concern?
Yes No INSTALL a new ABS module.
CHECK OASIS for any applicable TSBs. If a TSB exists for this concern, DISCONTINUE this test and FOLLOW the TSB instructions. If no TSBs address this concern, INSTALL a new ABS module.REFER to MODULE COMMUNICATIONS NETWORK and CARRY OUT the ABS module does not respond to the diagnostic scan tool pinpoint test.