LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2016 >> Focus S, Automatic DCT Trans, Gas >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls - Pinpoint Test H: Fuel Control Through Pinpoint Test JD: Crankshaft Position (CKP) Sensor - (Except Diesel & Hybrid) >> Pinpoint Test Hd: Misfire Detection Monitor >> Introduction
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pinpoint Test Hd: Misfire Detection Monitor: Introduction

NOTE: Mechanical noise caused by the front end accessory drive components, mechanically driven cooling fans, or rough roads at high RPM with light load conditions may produce a non-symmetrical loss of cylinder acceleration, which may result in a misfire.

This pinpoint test is intended to diagnose the misfire detection monitor.

Clearing the powertrain control module (PCM) diagnostic trouble codes (DTCs) erases any PCM recorded freeze frame data. Make sure to record any PCM freeze frame information before proceeding. Refer to FREEZE FRAME DATA .

scientia non olet · About LEMON Manuals