Remote Function Actuator Module (RFA) DTC Table
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B10AB:00 | Remote Keyless Entry Synchronization: No Sub Type Information | GO to Pinpoint Test R |
| B10C1:24 | Left Front Unlock Pull Switch: Signal Stuck High | GO to Pinpoint Test W |
| B10C3:24 | Right Front Unlock Pull Switch: Signal Stuck High | GO to Pinpoint Test W |
| B10C5:24 | Trunk Unlock Pull Switch: Signal Stuck High | GO to Pinpoint Test M |
| B10C6:1F | Exterior Trunk Antenna: Circuit Intermittent | GO to Pinpoint Test X |
| B10D1:24 | Left Front Lock button: Signal Stuck High | GO to Pinpoint Test W |
| B10D3:24 | Right Front Lock button: Signal Stuck High | GO to Pinpoint Test W |
| B12EE:11 | Liftgate/Tailgate/Trunk Release: Circuit Short To Ground | GO to Pinpoint Test M |
| B1361:31 | Front Right Door Handle Lock Circuit: No Signal | GO to Pinpoint Test W |
| B1365:31 | Front Left Door Handle Lock Circuit: No Signal | GO to Pinpoint Test W |
| B136F:31 | Left Front Door Handle Unlock Circuit: No Signal | GO to Pinpoint Test W |
| B1370:23 | Door Handle Ground Supply: Signal Stuck Low | GO to Pinpoint Test W |
| B1370:24 | Door Handle Ground Supply: Signal Stuck High | GO to Pinpoint Test W |
| B1373:31 | Front Right Door Handle Unlock Circuit: No Signal | GO to Pinpoint Test W |
| U201F:00 | External Receiver: No Sub Type Information | GO to Pinpoint Test R |
| U201F:13 | External Receiver: Circuit Open | GO to Pinpoint Test R |
| U201F:29 | External Receiver: Signal Invalid | GO to Pinpoint Test R |
| U201F:4A | External Receiver: Incorrect Component Installed | CARRY OUT the PMI procedure for the RFA module using as-built data. CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the RFA module self-test. If DTC U201F:4A returns, INSTALL a correct Radio Frequency (RF) receiver. REFER to: Radio Frequency (RF) Receiver |
| All other Diagnostic Trouble Codes (DTCs) | - | REFER to: Remote Function Actuator (RFA) Module |