Body Control Module (BCM)
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B1175:01 | Driver Door Ajar Switch: General Electrical Failure | GO to Pinpoint Test C |
| B1176:01 | Passenger Door Ajar Switch: General Electrical Failure | GO to Pinpoint Test C |
| B11C0:01 | Driver Side Rear Door Ajar Switch: General Electrical Failure | GO to Pinpoint Test C |
| B11C1:01 | Passenger Side Rear Door Ajar Switch: General Electrical Failure | GO to Pinpoint Test C |
| B1313:11 | Interior Lighting Output: Circuit Short To Ground | If the interior courtesy lamps are always on, GO to Pinpoint Test D If the interior courtesy lamps are inoperative, GO to Pinpoint Test B |
| B1313:15 | Interior Lighting Output: Circuit Short To Battery or Open | If the interior courtesy lamps are always on, GO to Pinpoint Test D If the interior courtesy lamps are inoperative, GO to Pinpoint Test B |
| B145C:11 | Ambient Lighting Power Supply Output: Circuit Short To Ground | GO to Pinpoint Test H |
| B145C:15 | Ambient Lighting Power Supply Output: Circuit Short To Battery or Open | GO to Pinpoint Test H |
| B1465:00 | Ambient Lighting Bus 1: No Sub Type Information | GO to Pinpoint Test J |
| B1467:00 | Ambient Lighting Bus 3: No Sub Type Information | GO to Pinpoint Test J |
| U1000:00 | Solid State Driver Protection Actived -Driver Disabled: No Sub Type Information | The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test. |
| U3000:49 | Control Module: Internal Electronic Failure | The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. The cause of the excessive current draw MUST be corrected before a new BCM is installed. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, Refer to BCM Hardware Testing (Hybrid/Energi) . For additional information on BCM Field Effect Transistor (FET) protection, REFER to: Module Controlled Functions - System Operation and Component Description . |