Cruise Control Operation

NOTE: For a complete illustration of the adaptive cruise control indicators and graphic displays, refer to the Owner's Literature.

The adaptive cruise control system functions much like a standard cruise control system. The adaptive cruise control system automatically adjusts the vehicle speed to maintain a set distance gap from the front of the vehicle and the vehicle in the same path of travel. When the adaptive cruise control system is on and is following a vehicle or a vehicle enters the same driving lane, a follow vehicle graphic is displayed in the message center.

The adaptive cruise control system does not function if the vehicle speed is below 20 km/h (12 mph). As the vehicle slows down during automatic braking, the adaptive cruise control system discontinues braking at 20 km/h (12 mph). At that speed, an audible alarm sounds and the automatic braking from the ABS module is released. The driver must take over the vehicle braking control.

The cruise control deactivator switch (which is integral to the BPP switch) is an additional safety feature. When the brake pedal is pressed, an electrical signal is sent from the BPP switch to the PCM deactivating the cruise control system. Under increased brake pedal effort, the cruise control system deactivator switch opens and removes the ground signal from the PCM input circuit, releasing the throttle and immediately deactivating the system.

The CCM monitors the yaw rate signal from the ABS module and compares it to the wheel speed and steering wheel angle signals. If the ABS module determines the yaw rate is invalid, the CCM disables the adaptive cruise control. The message center displays the message COLLISION WARNING MALFUNCTION and/or ADAPTIVE CRUISE MALFUNCTION.

The CCM monitors the environment in front of the vehicle while active. If the radar beam is obstructed by a buildup of snow, ice, rain or other debris, or the vehicle is driven in a desert environment with no other traffic for extended periods of time, the sensor will trigger a "Radar Blocked" message and will disable the adaptive cruise control. The adaptive cruise control will resume once the obstruction is cleared and the radar is able to detect targets, or upon a key cycle.

The ABS module estimates brake temperature by monitoring applied brake pressure over a period of time and sends a message to the CCM when the estimated temperature is above a given threshold. An alarm sounds and the adaptive cruise control system is deactivated until the estimated brake temperature returns to cooler operating conditions. This condition can happen in a hilly or mountainous driving terrain.