LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2017 >> Edge SE, FWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Electronic Engine Controls System - 2.0L ECOBOOST (184KW/250PS) - Mi4 >> Removal And Installation >> Powertrain Control Module (PCM) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (PCM): Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. 1.

    NOTE: This step is only necessary when installing a new component.

    Download the module information to the diagnostic tool using the Programmable Modules Installation routine. Refer to: Module Configuration - System Operation and Component Description . Use the General Equipment: Ford Diagnostic Equipment

  1. 1.

    NOTE: Do not pull the engine appearance cover forward or sideways to remove. Failure to press straight upward on the underside of the cover at the attachment points may result in damage to the cover or engine components.
    1. Place your hand under the engine appearance cover at each grommet location and push straight up to release each grommet from the studs.
    2. After all of the grommets have been released from the studs, remove the appearance cover from the engine.
GFD19519Courtesy of FORD MOTOR COMPANY

  1. 3.

    Disconnect the PCM harness connectors.
GFD19795Courtesy of FORD MOTOR COMPANY

  1. 4.

    Remove the retainers and the PCM.

    Torque: 89 lb.in (10 Nm)

GFD19796Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals