September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Selector Lever Cable - Column Shift: Installation
- 1.
Install the selector lever cable and connect the selector lever cable to the selector lever cable bracket.
- Route the cable over the transmission and push the selector lever end of the cable through the floor.
 Courtesy of FORD MOTOR COMPANY
|
- 2.
Attach the selector lever cable to the routing clip.
 Courtesy of FORD MOTOR COMPANY
|
- 3.
Pull the rubber grommet and selector lever cable through the floor pan.
 Courtesy of FORD MOTOR COMPANY
|
- 4.
Install the console LH finish panel.
 Courtesy of FORD MOTOR COMPANY
|
- 5.
Connect the selector lever cable to the selector lever cable bracket and the selector lever arm.
 Courtesy of FORD MOTOR COMPANY
|
- 6.
If necessary, rotate the cable adjustment lock upward.
 Courtesy of FORD MOTOR COMPANY
|
- 7.
Place the manual control lever in the DRIVE position.
- 1.
Rotate the manual control lever clockwise until it stops.
- 2.
Rotate the manual control lever counterclockwise 3 detents to the DRIVE position.
 Courtesy of FORD MOTOR COMPANY
|
- 8.
Connect the selector lever cable to the manual control lever and move the locking tab down.
- Listen for the audible click, then push back on the locking tab to verify it is locked.
- Pull back on the selector lever cable to verify it is installed correctly to the manual lever.
 Courtesy of FORD MOTOR COMPANY
|
- 9.
Install the transmission shield and rotate the 1/4 turn retainers.
 Courtesy of FORD MOTOR COMPANY
|
- 10.
Install the steering column shrouds. Refer to
Steering Column
.
- 11.
Verify the vehicle will start in PARK and NEUTRAL and the backup lamps illuminate in REVERSE.