Pinpoint Test E : P2535 (Without Push Button Start): Notes
Refer to Starting System for schematic and connector information.
Normal Operation and Fault Conditions
When the ignition is turned to the START position the PCM receives a voltage signal on the crank detect circuit. The PCM then supplies voltage and ground to the starter relay coil when the required inputs have been received.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P2535 | Ignition Switch Run/Start Position Circuit High | This DTC sets when the PCM detects voltage on the crank detect circuit while the engine is running. |
Possible Sources
- BCM
- Ignition switch
- PCM
- Wiring, terminals or connectors