Inspection And Verification

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to Diagnostic Methods .

Fig 1: High-Current Battery Junction Box Connector - C1035F

Courtesy of FORD MOTOR CO.

Fig 2: PSCM-A Connector - C1463A

Courtesy of FORD MOTOR CO.

Fig 3: PSCM-B Connector - C1463B

Courtesy of FORD MOTOR CO.

1. IV1: VISUAL INSPECTION 
   NOTE: The ignition must be off, and remain off, when disconnecting PSCM electrical connectors. Failure to follow this direction may lead to DTCs being set in the PSCM which cannot be cleared and result in the need to install a new EPAS steering gear.
   NOTE: If equipped, the Lane Keeping System (LKS) can interfere with accurate EPAS diagnostics. Disable the Lane Keeping System (LKS) before test driving the vehicle to diagnose EPAS concerns. For information on disabling the Lane Keeping System (LKS), refer to the Owner's Literature.
   NOTE: When inspecting the bellows boots make sure to use a strong light source and an inspection mirror.
   • Verify the customer concern.
   • Visually inspect the EPAS system for obvious signs of mechanical or electrical damage.
     VISUAL INSPECTION CHART
     
     

     Mechanical	Electrical
     Tire pressure	High-current BJB fuse 102 (100A)
     Tire condition and wear	BJB fuse 31 (10A)
     Loose steering column shaft bolts	Wiring, terminals or connectors
     Binding or misaligned steering column
     Steering column shaft couplings and U-joints
     Steering column shaft dash boot
     Steering gear
     Steering gear bellows boots
     Inner tie rod ends
     Outer tie rod ends

   • Is an obvious cause for an observed or reported concern found? 

     Yes	No
     Go to  IV2.	Go to KNOWN CONCERNS

2. IV2: DAMAGED STEERING GEAR BELLOWS BOOT 
   • Was a damaged steering gear bellows boot identified during the visual inspection? 

     Yes	No
     Go to  IV3.	REPAIR the concern identified during the visual inspection.

3. IV3: ISOLATE THE DAMAGED BELLOWS BOOT(S) AS THE CONCERN 
   • Review the repair order and verify there are no customer concerns (such as a message on the message center or NVH steering system concern) in addition to the damaged bellows boot(s).
   • Are any other customer concerns present? 

     Yes	No
     Make note of the damaged bellows boot(s). Go to KNOWN CONCERNS  After diagnosis is complete, if a new EPAS gear or bellows boot has not been installed, Go to PINPOINT TEST K .	Go to PINPOINT TEST K .