Charging System DTCS: BCM
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B11DB:02 | Battery Monitoring Module "A", General Signal Failure | GO to Pinpoint Test A |
| B11DB:08 | Battery Monitoring Module "A", Bus Signal / Message Failure | GO to Pinpoint Test A |
| B11DB:11 | Battery Monitoring Module "A", Circuit Short To Ground | GO to Pinpoint Test A |
| B11DB:49 | Battery Monitoring Module "A", Internal Electronic Failure | CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the BCM self test. If Diagnostic Trouble Codes (DTCs) B11DB:49 is retrieved, INSTALL new Battery Monitoring Sensor. REFER to: Battery Monitoring Sensor . |
| B11DB:55 | Battery Monitoring Module "A", Not Configured | CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect PMI procedures. INSTALL As-Built data from Professional Technician Society (PTS) following diagnostic scan tool instructions under Module Programming>As-Built. |
| B11DB:83 | Battery Monitoring Module "A": Value of Signal Protection Calculation Incorrect | GO to Pinpoint Test A |
| B11DB:96 | Battery Monitoring Module hardware fault | GO to Pinpoint Test A |
| B11DB:9A | Battery Monitoring Module "A", Component or System Operating Conditions | GO to Pinpoint Test A |
| B130C:12 | Load Shed Control: Circuit Short To Battery | The BCM monitors an unused load shed relay control circuit. If this DTC sets, disregard and diagnose other Diagnostic Trouble Codes (DTCs) or symptoms as required. |
| B130C:14 | Load Shed Control: Circuit Short To Ground or Open | The BCM monitors an unused load shed relay control circuit. If this DTC sets, disregard and diagnose other Diagnostic Trouble Codes (DTCs) or symptoms as required. |
| U1007:00 | Lost communication with Battery Monitoring Sensor "A": No Sub Type Information | GO to Pinpoint Test A |
| All Other DTCs | - | REFER to: Body Control Module (BCM) . |