LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2017 >> Fusion Energi Titanium >> Repair and Diagnosis >> External Pages >> Different car >> Section 195 (Body Panel System - Body Closures) >> General Procedures >> Liftgate Alignment
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Liftgate Alignment

WARNING: This page is about a different car, the 2015 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.

  1. 1.

    Loosen the 4 liftgate hinge-to-liftgate bolts until the liftgate is able to move slightly.

  1. 2.

    Align the liftgate to the body. For additional information, refer to margins in Body Repairs .

  1. 3.

    Tighten the 4 liftgate hinge-to-liftgate bolts.
    • Tighten to 30 Nm (22 lb-ft).

  1. 4.

    Position aside the liftgate weatherstrip.

  1. 5.

    Remove the liftgate scuff plate pin-type retainers.
GFD95051Courtesy of FORD MOTOR COMPANY

  1. 6.

    NOTE: To avoid damage to the liftgate scuff plate trim panel, remove any retaining clips from the body and attach them to the liftgate scuff plate trim panel before installing.

    Remove the liftgate scuff plate.

    • Pull upward to release the retaining clips.

  1. 7.

    Loosen the 2 liftgate striker bolts until the striker is able to move slightly.

  1. 8.

    Align the liftgate striker to the liftgate.

  1. 9.

    Tighten the 2 liftgate striker bolts.
    • Tighten to 25 Nm (18 lb-ft).

  1. 10.

    Initialize the power liftgate. For additional information, refer to Power Liftgate Initialization .
scientia non olet · About LEMON Manuals