Fuel Pump Driver Module (FPDM): Removal
WARNING:
Do not work on the fuel system until the pressure has been released and the engine has cooled. Fuel in the high-pressure fuel system is hot and under very high pressure. High-pressure fuel may cause cuts and contact with hot fuel may cause burns. Failure to follow these instructions may result in serious personal injury.
WARNING:
Clean all fuel residue from the engine compartment. If not removed, fuel residue may ignite when the engine is returned to operation. Failure to follow this instruction may result in serious personal injury.
NOTE:
The FPDM is located behind the LH C-pillar lower trim panel.
- Remove the LH C-pillar lower trim panel. Refer to: C-Pillar Lower Trim Panel .
-
- Disconnect the FPDM electrical connector.
- Remove the FPDM retaining nuts and then remove the FPDM.