Pinpoint Test E : The Traction Control System Cannot Be Disabled
- E1 VERIFY THE KEY IN USE IS NOT RESTRICTED
- Place 1 key inside the vehicle and all other keys at least 1 meter (3 feet) away from the vehicle.
- Turn the ignition to the ON mode.
- Monitor the message center.
Does the message center display MYKEY ACTIVE DRIVE SAFELY?
Yes The current key is a restricted key and is functioning correctly. REPEAT the test using different keys until the message center does not display MYKEY ACTIVE DRIVE SAFELY. GO to E2 No GO to E2 - E2 VERIFY THE MYKEY ® TRACTION CONTROL SETTING IN THE MYKEY ® MENU
- Using the message center, verify the MyKey ® traction control setting. Refer to the Owner's Literature for information on setting the MyKey ® functions.
Is the MyKey ® traction control setting configured to "always on"?
Yes GO to E3 No GO to E4 - E3 VERIFY THE TRACTION CONTROL FUNCTION CAN BE DISABLED USING THE ADMIN KEY IN THE DRIVER ASSIST MENU
- Using the message center, verify the traction control function can be enabled and disabled using the admin key. Refer to the Owner's Literature for information on enabling and disabling the traction control function.
Can the traction control function can be enabled and disabled using the admin key?
Yes The system is operating correctly at this time. The concern was most likely caused by the use of a restricted key. INFORM the customer the traction control function can only be disabled using an admin key when the MyKey ® traction control setting is configured to "always on". No GO to E4 - E4 CHECK FOR ABS (ANTI-LOCK BRAKE SYSTEM) MODULE DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, carry out the ABS self-test.
- Retrieve and record all ABS Diagnostic Trouble Codes (DTCs).
Are there any ABS Diagnostic Trouble Codes (DTCs) present?
Yes GO to the DTC Chart: Anti-Lock Brake System (ABS) Module. No GO to E5 - E5 CHECK FOR GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, carry out the GWM self-test.
- Retrieve and record all GWM Diagnostic Trouble Codes (DTCs).
Are any Diagnostic Trouble Codes (DTCs) present in the GWM?
Yes GO to the DTC Chart: GWM. Refer to: Communications Network . No GO to E6 - E6 CHECK FOR IPC (INSTRUMENT PANEL CLUSTER) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, carry out the IPC self-test.
- Retrieve and record all IPC Diagnostic Trouble Codes (DTCs).
Are there any IPC Diagnostic Trouble Codes (DTCs) present?
Yes GO to the DTC Chart: Instrument Panel Cluster (IPC) REFER to: Instrumentation, Message Center and Warning Chimes . No The system is operating correctly at this time. The concern may have been caused due to high network traffic or an intermittent fault condition.