April 5, 2026: LEMON Manuals is launched! Read the announcement.

Vertical Alignment

NOTE: In order to align the Cruise-Control Module (C-CM), which is a radar sensor unit, the vehicle must be in a wheel alignment bay station so that the vehicle is level.

NOTE: Damage to the C-CM bracket may affect correct alignment. When aligning the C-CM, inspect the C-CM bracket for damage and repair as necessary before carrying out the alignment procedure.

1.

Place the vehicle on a wheel alignment bay station.

2.

Remove the C-CM radar sensor unit fascia cover.

3.

Locate the C-CM radar sensor alignment screw.

GFD85563

Courtesy of FORD MOTOR COMPANY

4.

Place a combination square level on the face of the C-CM radar sensor unit and check alignment.

GFD85564

Courtesy of FORD MOTOR COMPANY

5.

Keeping the combination square level on the face of the C-CM radar sensor unit, adjust the pitch of the sensor by using an E5 inverted Torx bit to adjust the screw until the sensor is vertical and level.

GFD85565

Courtesy of FORD MOTOR COMPANY

6.

NOTE: Prior to installing the C-CM radar sensor unit fascia cover, clean and remove any debris on the front or back of the cover.

Install the C-CM radar sensor unit fascia cover.